Toshiba MMC-UP0151HP-E, Руководство по обслуживанию

Страница: 96 / 295

In case of wireless remote controller
1
Turn on the power of the air conditioner.
When power is turned on for the first time after installation, it takes approx. 5 minutes until the remote
controller becomes available. In the case of subsequent power-on, it takes approx. 1 minute until the remote
controller becomes available.
Execute a test run after the predetermined time has passed.
2
Push “ON/OFF” button on the remote controller, select [ Cool ] or [ Heat ] with “MODE” button, and
then select [ HIGH ] with “FAN” button.
3
Cooling test run Heating test run
Set the temperature to 17 ˚C
with the temp. setup buttons. Set the temperature to 30 ˚C
with the temp. setup buttons.
Cooling test run Heating test run
After confirming a signal
receiving sound “beep”
immediately set the
temperature to 18 ˚C with
the temp. setup buttons. After confirming a signal
receiving sound “beep”
immediately set the
temperature to 29 ˚C with
the temp. setup buttons.
Cooling test run Heating test run
After confirming a signal
receiving sound “beep”
immediately set the
temperature to 17 ˚C with
the temp. setup buttons. After confirming a signal
receiving sound “beep”
immediately set the
temperature to 30 ˚C with
the temp. setup buttons.
4
5
6
Repeat procedures
4
o o
o o
o
5
o o
o o
o
4
o o
o o
o
5
.
Indicators “Operation” (green), “Timer” (green), and “Ready” (orange) in the wireless receiver section flash
in approx. 10 seconds, and the air conditioner starts operation. If any of these indicators does not flash,
repeat procedures 2 to 5.
7
Upon completion of the test run, push “ON/OFF” button to stop operation.
<Overview of test run operations using the
wireless remote controller>
Cooling test run:
ON/OFF
o
17 °C
o
18 °C
o
17 °C
o
18 °C
o
17 °C
o
18 °C
o
17 °C
o
(test run)
o
ON/OFF
Heating test run:
ON/OFF o 30 °C o 29 °C o 30 °C o 29 °C o 30 °C o 29 °C o 30 °C o (test run) o ON/OFF
- 96 -