© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO163/166/203/206
ADJUSTMENT
3 - 9
3
[D] Secondary scanning data laser writing start position
This adjustment has to be performed for each paper source. (If there is no paper source, skip this step.)
The following table shows the order of the paper source to be adjusted, code, paper size and accept-
able values.
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON. (Adjustment Mode)
(2) Press [1] [INTERRUPT] [Drawer number] (Select from 0: bypass, 1: drawer or 2: PFU.)
[START]. (A grid pattern with 10 mm squares is printed out.)
(3) Check the grid pattern on the test chart printed out and measure the distance D from the leading
edge of the paper to the 6th line of the grid pattern.
*Normally, the 1st line of the grid pattern is not printed.
(4) Check if the distance D is within 50±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance D again.
(Adjustment Mode) (Key in the code shown above) [START]
(Key in an acceptable value shown above)
[INTERRUPT] (Stored in memory) “AJ” is displayed
Press [1] [INTERRUPT] Press [Drawer number] [START]
(A grid pattern is printed out.)
*The larger the adjustment value is, the longer the distance D becomes (approx. 0.4 mm/step).
Order for
adjustment
Paper source
Code
Paper size
Acceptable
value
Remarks
1
Drawer
440
A3/LD
0 to 40
2
PFU
441
A4/LT
0 to 40
3
Bypass feed
442
A4/LT
0 to 15
06/04
Содержание e-STUDIO163
