4. SYSTEM MODE (For Service Persons and System Administrators)
EO13-33005
4.5 Printer Parameter Fine Adjustment
4- 49
Regardless of gap length, the stop position in strip issue mode is
designed in a manner so that printing stops when the distance from
the top edge of the strip shaft to the trailing edge of the label is 2.35
mm, if print position fine adjustment value is not set.
If the above-mentioned stop position is not proper, the stop position
should be adjusted using the stop position fine adjust function for
the strip issue.
Notes:
1 When
the
[FEED]
key is pressed, the menu moves in the opposite direction from when the
[PAUSE]
key is pressed.
2 When
the
[PAUSE]
key is pressed while the
[FEED]
key is held down, or when the
[POWER]
key is
pressed for 3 seconds or more, the display returns to the system mode menu (ADJUST SET).
3 When
the
[PAUSE]
key or
[FEED]
key is pressed for 0.5 seconds or more during this fine adjustment
setting, repeat mode is enabled and the key pressed is repeatedly entered.
4
The change in the fine adjustment value becomes effective when the
[POWER]
key is pressed after
setting, then stored in the backup memory.
5 The printer is controlled by the total amount determined by this command and the Position Fine
Adjustment command sent from the PC. However, the maximum value is –2.0 mm to +3.0 mm
6
The factory default value is +0.0mm.
3 mm ~ 7 mm
2.35 mm
Label
Strip Plate
