Toro 75500, Руководство оператора, Страница: 21 / 36

g027996
Figure 15
1. Full-width ramp in stowed
position 4. Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground
2. Side view of full-width
ramp in loading position 5. H=height of the trailer or
truck bed to the ground
3. Not greater than
12 degrees 6. Trailer
Loading the Machine
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death.
• Use extreme caution when operating a
machine on a ramp.
• Back the machine up the ramp and drive it
forward down the ramp.
• Avoid sudden acceleration or deceleration
while driving the machine on a ramp as
this could cause a loss of control or a
tip-over situation.
1. If using a trailer, connect it to the towing vehicle
and connect the safety chains.
2. If applicable, connect the trailer brakes and
lights.
3. Lower the ramp, ensuring that the angle
between the ramp and the ground does not
exceed 12 degrees (
Figure 15 ).
4. Back the machine up the ramp.
g028294
Figure 16
1. Back the machine up the
ramp.
2. Drive the machine forward
down the ramp.
5. Shut off the machine, remove the key, and
engage the parking brake.
6. Tie down the machine at the front and rear axles
with straps, chains, cable, or ropes. Refer to
local regulations for tie-down requirements.
g343282
Figure 17
1. Tie-down points
Unloading the Machine
1. Lower the ramp, ensuring that the angle
between the ramp and the ground does not
exceed 12 degrees (
Figure 15 ).
2. Drive the machine forward down the ramp
(
Figure 16 ).
21