Toro 46452, Руководство оператора

Страница: 12 / 36

4. Tighten the jam nut to secure the upper link arm
into position.
5. Start the traction unit and lift the attachment off
the ground.
Connecting the PTO
Driveshaft
Adjusting the PTO Driveshaft
Length
Adjust the length of the PTO driveshaft whenever you
install the attachment to a different traction unit.
Important:
If the length of PTO is not adjusted
properly, using the attachment can damage the
traction unit or the attachment. The overlapping
length of the cylinders must be at least 150 mm
(6 inches). The length changes when you lift or
install the attachment on a different traction unit.
1. Park the machine on a level surface, engage
the parking brake, and lower the attachment to
the ground.
2. Shut off the engine and remove the key.
3. Pull the PTO driveshaft sections apart ( Figure
11 ).
g347461
Figure 11
4. Assemble the outer PTO driveshaft section to
the traction-unit PTO output shaft (
Figure 12 ).
Note:
Pull on the driveshaft to ensure that the
locking pin engages the PTO output shaft.
g007328
Figure 12
1. PTO output shaft (traction
unit) 3. PTO driveshaft
2. PTO shaft coupler
5. Hold the driveshaft sections parallel to each
other to determine if they are too long (
Figure
13 ).
Note:
Each driveshaft section must be 76 mm
(3 inches) from the U-joint ( Figure 13 ).
6. If the driveshaft sections are too long, mark 76
mm (3 inches) back from U-joint on each section
(
Figure 13 ).
12