Toro 46452, Руководство оператора

Страница: 25 / 36

3. If the tension is not correct, loosen the locknuts
under the plate (
Figure 34 ).
4. Loosen the bolts in the slots ( Figure 34 ).
5. Adjust the locknuts on top to adjust the tension
of the belts.
6. Check the belt tension and if needed, continue
to adjust the top locknuts.
7. Tighten the lower locknuts under the plate
(
Figure 34 ).
8. Tighten the top locknuts.
9. Tighten the bolts in the slots.
10. Install the belt cover.
g346866
Figure 33
1. Top locknuts 3. Lower locknuts
2. Belts
g346867
Figure 34
1. Bolt in slot 2. Pivot bolt
Adjusting the Conveyor
Belt Alignment
If the conveyor belt starts slipping or moving sideways
after use or after new installation, adjust the conveyor
belt tension.
1. Check if the rollers and the inside of the
conveyor belt are clean. If necessary clean the
rollers and remove any dirt inside.
2. Release the tension of the conveyor belt by
loosening the left and right screws.
3. Mark both sides of the belt with 2 measurement
marks a distance of 1000 mm (39-13/32 inch)
apart; refer to
Figure 35 .
25