Toro 46452, Руководство оператора

Страница: 8 / 36

2
Inspecting the Machine
No Parts Required
Checking the Grease and Gearbox
Check and ensure that the gearbox has fluid; refer to
Checking the Gearbox Lubrication (page 23) .
Ensure that the machine is greased before use; refer
to
Greasing the Attachment (page 22) .
Checking the Traction Unit
Requirements
Use the following figure and list as a reference:
•
Refer to the specifications section for the minimum
horse power, maximum horse power, and the
minimum lifting capacity;
Specifications (page 9) .
•
The traction unit must have a category II or III
3-point hitch.
•
The traction unit must have a PTO output-shaft
speed of 540 rpm.
•
Adequate front-end weight (ballast) to offset the
weight of the machine.
•
Check the tire air pressure of the traction unit.
Adjust the tire air pressure as needed.
Important:
Do not exceed the maximum
or minimum tire inflation pressures as
recommended by tire manufacturer.
g007332
Figure 5
3-Point Hitch and PTO Components
1. Lower link arm 3. PTO driveshaft
2. Upper link arm 4. Sway link
Checking the Ballast
Requirements
WARNING
Mounting the machine to the rear of the
traction unit decreases the weight on its front
axle.
Failure to add required ballast may result in
an accident and severe injury or death.
• To ensure adequate steering control and
stability you may need to add ballast to the
front of the traction unit.
• Refer to the traction unit operator's manual
for ballast requirements.
8