Toro 136-0372, Руководство по установке

Страница: 35 / 64

Figure 70
1. Sprayer supply hose—2.5
x 73 cm (1 x 28-7/8 inches) 5. Filter head
2. 90° flanged elbow 6. Straight barbed fitting
3. Flange clamp—40 to
64 mm (1-9/16 to 2-1/2
inches) 7. Retainer
4. Gasket—25 x 35 mm (1 x
1-3/8 inches) 8. T-fitting (forward, left
position)
2. Loosely assemble the sprayer supply hose and gasket
to the filter head (
Figure 70 ) with a flange clamp—40
to 64 mm (1-9/16 to 2-1/2 inches).
3. Route the sprayer supply hose down and toward the
T-fitting located forward of the pressure-relief valve as
shown in
Figure 71 .
Figure 71
1. Sprayer supply hose—2.5 x 73 cm (1 x 28-7/8 inches)
4. Assemble the straight barbed fitting of the sprayer
supply hose into the forward, left T-fitting (
Figure 70 ).
5. Secure the barbed fitting to the T-fitting with the
retainer that you removed in step
3 of Disconnecting
the Return, Sprayer-Supply, and Bypass Hoses (page
14)
.
6. Secure the hose to the sprayer supply hose to the tab
of the agitation-valve bracket (
Figure 72 ) with the
flange-head bolt (5/16 x 3/4 inch) and flange locknut
(5/16 inch).
Figure 72
1. Flange locknut (5/16 inch) 3. Support clamp
2. Agitation-valve bracket 4. Flange-head bolt (5/16 x
3/4 inch)
7. Tighten the flange clamp that secures the 90° flanged
elbow of the sprayer supply hose to the filter head
(
Figure 70 ).
35