Positioning the Turf Compensating
Spring
Cutting Unit 2
g379514
Figure 15
1.
Cutting unit 1
5.
Cutting unit 5
2.
Cutting unit 2
6.
Reel motor
3.
Cutting unit 3
7.
Weight
4.
Cutting unit 4
1.
If the hairpin is installed in the rear hole of the
compensation-spring rod—remove the hairpin
and insert it in the hole next to the bracket
(
).
g375689
Figure 16
1.
Hairpin
2.
Remove the 2 flange locknuts (3/8 inch) and 2
carriage bolts (3/8 x 1-1/4 inches) that secure
the turf-compensator bracket to the cutting-unit
frame (
).
g375690
Figure 17
1.
Carriage bolt (3/8 x 1-1/4
inches)
3.
Flange locknut (3/8 inch)
2.
Turf-compensator bracket
3.
Remove the flange locknut (3/8 inch) that
secures the capscrew of the turf compensation
spring to the right tab of the carrier frame,
and remove the compensation spring from the
cutting unit (
).
Note:
Do not remove the flange serrated nut
from the capscrew.
g375691
Figure 18
1.
Capscrew
3.
Flange locknut (3/8 inch)
2.
Right tab (Carrier frame)
4.
Assemble the capscrew of the turf compensation
spring to the right tab of the carrier frame (
) with the flange locknut (3/8 inch).
14
