Toro 03781, Руководство оператора

Страница: 44 / 76

Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours Grease the bearings
and bushings immediately after
washing the machine.
Grease Specification: No. 2 lithium grease
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page 41) .
2. The grease fitting locations and quantities are
as follows:
•
Brake shaft pivot bearings (5), refer to Figure
67
g009704
Figure 67
•
Rear axle-pivot bushing and steering
cylinder, refer to
Figure 68
g380870
Figure 68
•
Steering cylinder ball joints (2), refer to
Figure 69
g009706
Figure 69
1. Top fitting on king pin
•
Tie rod ball joints (2), refer to Figure 69
•
King pin bushings (2), refer to Figure 69 .
Note:
The top fitting on the king pin should
only be lubricated annually (2 pumps).
•
Lift arm bushings (1 per cutting unit), refer
to
Figure 70
g015159
Figure 70
•
Lift cylinder bushings (2 per cutting unit),
refer to
Figure 70
44