Tormatic POWERSLIDE, Инструкция по эксплуатации

Страница: 42 / 92

PowerSlide 12
ENGLISH
 1 0
14
90
8-18
30
 1 1
2x17
0 1 2 3 4 5 6
 1 2
50
328
172
1
5.3 BASE PLATE
RISKS
PERSONAL PROTECTIVE EQUIPMENT
L i
Before proceeding, check that the necessary conduits are in place
(§ -
 5
).
The base plate and corresponding hardware are accessories which are
not included.
1. Assemble the base plate as shown in
 1 1
; tighten the supplied
M10 nuts and locknuts, using two hex spanners.
2. Pour a slab, with reference to
 6
and
 7
in § and
 1 2
.
3. Take the cable conduits out from the hole (
 1 2
-1) and install
the base plate.
L i
Do not bury the base plate in the concrete.
4. Use a spirit level to check that the slab is horizontal, making any
corrections before the concrete goes off (
 1 2
).
5.4 FASTENING THE GEAR MOTOR
RISKS
PERSONAL PROTECTIVE EQUIPMENT
L i
Wait for the concrete to cure fully before proceeding.
!
Lift the gear motor, holding it by the base.
1. Pass the cables through the two holes on the gear motor (
 1 3
-1).
2. Position the gear motor, lining up the slots and the screws on the
plate (
 1 3
-2).
3. Pass the cables through the supplied cable glands, then insert the
cable glands in the holes (
 1 3
-3).
Steel rack
Foundation