TopCold Romeo, Руководство пользователя, Страница: 11 / 16

22
Modifying the parameters
Parameter navigation
The operating parameters, modifiable using the keypad, are divided into two types: frequent (type F) and configura-
tion (type C). Access to the latter is protected by password (default= 22) to prevent accidental or unauthorized modifi-
cations.
Accessing the type F parameters:

press the SET button for more than 3 s (if there are active alarms, mute the buzzer), the display shows the parame-
ter code ‘PS’ (password);

use the UP and DOWN buttons to scroll the parameters. The LED corresponding to the category of parameters
will be on (see Table 5.b);

press SET to display the value associated with the parameter increase or decrease the value using the UP or
DOWN button respectively;

press SET to temporarily save the new value and display the parameter again;

repeat the procedure for any other parameters that need to be modified;

press the SET button for more than 3 s to permanently save the parameters and exit the parameter setting proce-
dure.
Accessing the type C parameters:

press the SET button for more than 3 s (if there are active alarms, mute the buzzer), the display shows the parame-
ter code “PS” (password);

press the SET button to access the password setting;

use the UP and DOWN buttons to scroll the numbers until displaying “22” (password to access the parameters);

press the SET button to confirm the password;

use the UP and DOWN buttons to scroll the parameters. The LED corresponding to the category of parameters
will be on (see Table 5.b);

press SET to display the value associated with the parameter increase or decrease the value using the UP or
DOWN button respectively;

press SET to temporarily save the new value and display the parameter again;

repeat the procedure for any other parameters that need to be modified;

press the SET button for more than 3 s to permanently save the parameters and exit the parameter setting proce-
dure.
Setting the default parameters
To reset the default parameters:

disconnect power from the instrument;
11
4. Unpack
ing
RECEPTION OF THE MATERIAL
Proper installation is the first step to operation. We recommend that your refrigerator be in-
stalled by authorized Frilixa Certified Installer.
All units are performance tested and thoroughly inspected prior to shipment. Upon leaving the fac-
tory, all units are in perfect condition. Upon receipt, examine the exterior of the shipment packaging
for any signs of rough handling. If the cabinet is damaged, it should be note on the delivery slip or bill
of lading and signed. A claim must be filled immediately against the carrier indicating the extent and
estimated cost of damage incurred.
UNPACKING
Tools Needed: Crowbar  Level 
WARNING : Never lay your refrigerator down on either its back, front or sides. This allows compressor
oil into the refrigerant lines which can damage the compressor at start-up. If the unit is laid down, it
must be set upright for a minimum of 12 hours before starting the compressor. Failure to adhere to
the above recommendation will void the warranty.
1. Split plastic wrap along one of the cardboard posts. Remove and discard all packaging material,
tape and interior components.
2. Move cabinet as close to final location as possible before removing skid.
3. Remove the shipping skid by tipping the cabinet forward. Remove the nails of carriage with a
crowbar in the following order:
1) Top Side;
2) Part Sides;
3) Part Front / Back;
4) Background.