Toparc 058866, Руководство пользователя

Страница: 10 / 30

Mobile service stations
EN
10
zone zone
II Surface industries 1 Very high level of protection 0 20
2 High level of protection 1 21
3 Normal level of protection 2 22
TECHNICAL DATA
General characteristics of machinel : Portable pneumatic suction cleaner for potentially explosive dust produced during
sanding or equivalent operations, with fitting for pneumatic tool
EX marking
II 3 D c T 50°C
Supply pressure 7 bar
Compressed air supply connection diameter 3/8”
Filter surface 0,5 m²
Filter material Antistatic polyester
BIA value C
Suction capacity 150 m3/h
Air consumption of suction cleaner 800 l/min
Vacuum level 2000 mmH2O
Dry dust capacity 20 liters
Noise level 78 dB
Protection factor IPX4
Dimensions 70x45x45h cm
Weight 18 kg
RECOMMENDATIONS
Safety and accident prevention instructions
The machine is a portable suction cleaner with a fitting for the connection of a pneumatic tool, which uses compressed
air at a pressure of 7 bar to vacuum sanding dust.
The machine is a portable suction cleaner with a fitting for the connection of a pneumatic tool, which uses compressed
air at a pressure of 7 bar to vacuum sanding dust.
The suction cleaner must be connected to a compressed air supply with a pressure 7 bar using a tube with an internal
diameter of 8mm minimum.
JBDC does not accept liability for any damage, direct or indirect, caused by the failure to comply with the instructions
provided in these manuals.
The machine must only be used by trained and qualified personnel.
The machine must be located in a dry and adequately ventilated area where air is changed at least once an hour with
50% of the total fresh air without the aid of special ventilation systems. The temperature of the work area must be
between 10°C and 40°C with humidity between 50% and 90%.
WARNINGS
- Do not vacuum sanding dust from surfaces treated with paints that have not completed the catalization cycle
- Do not vacuum aggressive liquids or substances (i.e. acids , bases, solvents, etc.)
- Do not vacuum flammable or explosive liquids (i.e. petrol, thinners, etc.)
- Do not vacuum potentially explosive gases or vapors
- In the event of leakage of dust from the unit, immediately close the compressed air supply of the vacuum cleaner
- In the event of a fire or explosion, follow internal safety instructions and procedures (as indicated in the ATEX 2014/34/
UE Directive)
- Always place appropriate warnings signaling the presence of a potentially hazardous atmosphere next to the area in
which the machine is being used (as indicated by Directive 2014/34/UE)
The machine complies with the ATEX 2014/34/UE Directive and harmonized standards listed in the declaration of confor -
mity as equipment in category II 3 D.
The machine bears the safety markings specified below.