Toolex 597077, Инструкция по эксплуатации

Страница: 12 / 27

12 / 27
12
order while you press . Also when it is
MMA welding, the button can adjust
(just decrease) ARC force.
17. 4#: Parameter Select (towards the
right)
：
You can choose any procedure
function
among “GAS
PRE-FLOW/GAS POST-FLOW,
STARTING AMP./FINAL
AMP. ,CURRENT UP
SLOPE/CURRENT DOWN
SLOPE,TIG, AC/PULSE
FREQUENCY, BASE AMP./PEAK
AMP.,CLEAN
WIDTH/CLEAN
SCOPE /PULSE WIDTH” by press
this button . The illumination indicator
stands for the current status you are
choosing.
The indicator will
illuminate from the left to right in
order while you press. Also when it is
MMA welding, the button can adjust
(just increase) ARC force.
18. 5#: “Parameter Adjustment Knob”:
After choosing the procedure function
(refer to item 4 and 5), the current
status are set, then you can turn this
knob to adjust its parameter value. For
example: GAS PRE-FLOW indicator
on, adjust “ADJUSTMENT PAR.” 6#
button to set “GAS PRE-FLOW/ GAS
POST-FLOW” time
（
3~0s/99.9-0s
）
;
When the “STARTING AMP.” indicator
on, adjust “ADJUSTMENT PAR 6#.”
button to set STARTING AMP. /FINAL
AMP. Current
（
315/270/250~/15A
）
;
and using the same way to adjust
beforehand
for the followings:
“CURRENT UP SLOPE/CURRENT
DOWN SLOPE” time
（
15~0S
）、
“TIG”
（
315/270/250~15A
） 、
“BASE
AMP./PEAK AMP.” current
（
315/270/250~/15A
）
/“PULSE
WIDTH ”
（
99%~1%
） 、
“AC”
（
100~20HZ
）
/“PULSE FREQ.”
（
500~0.2HZ(DC), 20~0.2HZ(AC)
）
;
“CLEAN WIDTH
（
+40~
-40%
）
”/“CLEAN SCOPE
（
30~ -15%
）
”
。
Long time pressing this button can
realize speediness adjustment. This
button
just can adjust these
parameters from high to low. Also it
can used for adjusting welding current
(from low to high) when the STICK is
used.
This welding machine can auto-save
data when it is power off, which could
be used directly of next time.
NOTE: Protection Code (May
showed on the digital display)
1. DISPLY 804: Machine auto-self
protection when it is over-heated
2. Display 805: Short circuit of the TIG
torch
Panel Instruction (
AC/DC TIG 200
)