Toolex 597077, Инструкция по эксплуатации

Страница: 17 / 27

17 / 27
17
Part Description Qty
1A Long Back Cap 1
2A Short Back Cap 1
3A1 Collet 1/16”
(1.6mm)
1
3A2 Collet 2/25”
(2.0mm)
1
3A3 Collet 3/32”
(2.4mm)
1
3A4 Collet 1/8”
(3.2mm)
1
4A Torch Handle 1
5A Collets Housing 1
6A1 Ceramic Nozzle
size 4; 10N50 1
6A2 Ceramic Nozzle
size 5; 10N49 1
6A3 Ceramic Nozzle
size 6; 10N48 1
6A4 Ceramic Nozzle
size 7; 10N47 1
(Refer to parts diagram above for Torch
Handle components.)
Direct torch away
from people and flammables while you
press (and hold) the Torch Handle Trigger
(2A) to energize the Torch Electrode (4A).
The air output is delayed a few seconds to
enable a proper arc to begin.
Caution : The Torch handle is now
energized. Be careful not touch anything
else with the Torch except the workpiece
to be welded.
3. Assemble the desired accessories and
rod inside the tip of the TIG Torch
handle.
a. Unscrew the Ceramic Nozzle (6A)
on the Torch Handle (4A).
b. Unscrew the Collect Housing (5A).
c. Place a 5/32” prepared tungsten
welding rod (not included) into the
torch.
d. Screw the Collect Housing and
Ceramic Nozzle back onto the
Torch.
4. Connect a hose and coupling from the
gas regulator on an Argon gas tank
(none included) to the Argon Gas Inlet
on the back of the unit. Follow the gas
cylinder manufacturer’s instructions for
set-up and use.
5. Verify that the Power Switch is in the
off position, then plug the 230V~line
cord plug into an appropriate
230V~outlet., and then turn Power
Switch of the power supply UP to the
ON position (refer to page 8 left)
6. Turn the SELECTION PAR. /FORCE
AMP” (4#.) and “ADJUSTMENT PAR.
/DCR AMP. (5#.)
to meet the needs of
the job.(refer to page 11)
7. When everything is in place for
welding press the torch and orient
yourself to one side of the area to be
welded, and move the Welding Helmet
Face Shield (not included, see page 4
item 7) over your eyes.
8. Hold the Trigger down and tilt the torch
forward. Keep a constant distance
between the torch and the work piece
but do not contact it.
DANGER! To prevent serious injury
and death: The TIG Welder will
immediately turn on when the
trigger is held down. When the
operator is not holding the Torch, it
must be sitting on a nonconductive,
1A
2
A
3A
4
A
5A
6A