TH2683A Operation Manual
Ver.1.3
10
MEAS SETUP> page.
MEAS STEP.
RANGE.
OUTP VOLT.
MONI VOLT.
MEAS MODE.
INTER RES.
3.1.1
Measurement Functions
Measurable parameters on TH2683A are as follows:
Primary Parameters
R
(Insulation resistance)
I
(Leakage current)
Secondary Parameter
T
(Time count value of each procedure)
The measurement results of primary parameters and secondary parameter are respectively
displayed in three lines in the form of large characters. The upper two lines indicate the primary
parameters, while the lower line shows the secondary parameter.
Note:
1.
Settings and modifications of all functions can be taken by the following steps: 1):
Touch the
corresponding function zone and then select the desired function in the soft key zone on
the right side of the screen;
2):
Use arrow buttons and [ENTER] button to set and modify
the corresponding function.
2.
Settings and modifications of all functions can only be taken in discharging state. Only
discharging key and start saving function response in measurement state.
3.2
<MEAS SETUP>
Touch the main menu and then touch the soft key <MEAS SETUP> to enter into the <
MEAS
SETUP
> page shown as figure 3
‐
2.
