20
3. Apply caulk tape (field supplied) directly
to the flange, below the screw pattern of the
joint to be fastened together.
4. Hoist accessory using all lifting lugs, if
provided; otherwise, a sling, to lift accessory
and center it over the panel opening.
5.
Affix the accessory to the unit using (field
supplied) self tapping screws. Make certain
every pre-punched hole in the flange is used in
fastening.
6. Repeat steps three through five to attach
the hood to the filter section;
except in step five
substitute ¼ inch bolts in for self taping screws
to attach the hood to the filter section.
7. After all of the accessories are installed,
caulk each seam to provide a water tight seal.
IMPORTANT: Re-caulk accessory
lifting lugs after assembly (if
applicable). Check all external sheet
metal seams for caulk shrinkage and re
-caulk if necessary.
Titan Air Inc. does
not warranty water damage equipment
.
Seam sealing integrity should be
rechecked on a yearly basis.
NOTICE: Access door swings MUST be
kept free of installation piping and
wiring to allow for service and
maintenance.
Caulk Tape
Caulk