Timewave PK-232 MBX, Руководство по эксплуатации

Страница: 18 / 266

PK-232 OPERATING MANUAL COMPUTER INSTALLATION
CHAPTER 2
COMPUTER INSTALLATION
2.1 Overview
In this chapter we will connect the PK-232 to the RS-232 Serial port
of your Computer or Computer Terminal. After the Serial connection
has been made we will perform a quick check of the PK-232 internal
software. Finally we will check the PK-232's internal modem by
performing a Packet "loop-back" test. When you have completed this
chapter, you will be ready to connect the PK-232 to your receiver or
transceiver and begin using it on the air.
2.1.1 Equipment Required
You will need the following for this chapter:
o your PK-232 Data controller;
o a 13.6-volt DC, 1-amp (or greater) regulated power supply such as
those sold by Radio Shack (or an AEA AC-4);
(the power supply must be able to supply at least 12 VDC to the
PK-232 while it is operating under load)
o the included PK-232 DC power cord unless the AC-4 is used;
o your Computer or Computer Terminal;
o a Communications or Terminal Emulation program for your computer;
o the included RS-232 cable with 25-pin "D" connectors on each end;
(do not use a 3rd-party RS-232 cable with more than pins 1-8 and
20 connected)
o one of the included 5-pin shielded "Radio cables";
(note that the radio cables may arrive as a single 10-ft. cable
which should be cut in half producing two 5-ft. cables.
o wire cutters and strippers or a small pocket knife, a small
straight-blade screwdriver and a medium phillips-head screwdriver.
2.2 Unpacking the PK-232
Carefully remove the PK-232 from the box and its plastic bag.
Inspect the unit for signs of damage that may have occurred in
shipping. If there is visible damage, please contact the dealer or
shipper. Do not attempt to install or use a damaged PK-232.
We will be discussing some of the Controls, Indicators and Connections
in this installation so take a few moments to familiarize yourself
with them. The figures on the next pages may help with their
locations.
4/91 2-1