Timespace X300 Series, Инструкция по эксплуатации

Страница: 85 / 94

85
PTZ CONTROLS
REVIEWER KEY PTZ FUNCTION
UP ARROW
TILT UP
DOWN ARROW TILT DOWN
LEFT ARROW PAN LEFT
RIGHT ARROW PAN RIGHT
NUMERIC 1-8 PRESET 1-8 *camera support required
9 ZOOM OUT
0 ZOOM IN
9-16 When a PTZ camera is selected in Live View, the 9-16 button
enables PTZ presets to be set. This is used in conjunction with
the STOP button to setup PTZ presets.
STOP There are 2 shifts states indicated by the STOP LED;
OFF = shift not enabled
ON = set preset / additional cmds
The following commands are only supported by the VISCA PTZ protocol;
REVIEWER KEY PTZ FUNCTION With shift enabled (STOP key)
<<
Focus Far Iris Open
< Focus Near Iris Closed
>> Auto Focus Auto Iris
SETTING PTZ PRESETS
1. Press the camera number of the PTZ camera you wish to assign presets to.
2. Press the 9-16 button on the Reviewer (
9-16 LED ON ).
3. Move the camera to the desired position / zoom level.
4. Press the STOP key (the STOP LED will illuminate and remain ON for 10 seconds)
5. Press the number key you wish to assign that preset position to.
The using the arrows to move the camera position, the X300 uses a PROGRESSIVE SPEED control. If
a directional arrow is held on the Reviewer, the camera will begin moving slowly, then speed up.