Timespace X300 Series, Инструкция по эксплуатации

Страница: 69 / 94

69
GPS
Global Positioning System serial connection setup menu.
The X300 can receive GPS data through the serial port and embed the data into recorded images. GPS
data includes positioning and speed and users can optionally turn these on or off. Then turned on, the
data will be recorded with each image.
The X300 is compatible with the standard NMEA-0183 GPS protocol. A suitable GPS serial unit can be
wired to specific pins on the X300 serial port (see X300 user manual for further information / wiring
diagrams).
EMBED GPS POSITION - When set to YES will embed the position information in recorded images.
EMBED GPS SPEED - When set to YES will embed the speed information in recorded images.
SPEED UNITS can be set for miles per hour (MPH) or kilometres per hour (KPH).
SYNC CLOCK WITH GPS - The X300 can be configured to synchronize the clock with the data and
time information received from the GPS unit. When set to YES the X300 will synchronize the clock on
power up.
GMT OFFSET
– When syncing with GPS time outside the UK, it is necessary to set the GMT offset for
the country / region that the X300 is in, +/- to GMT.
GPS/GSENSOR BAUD set the baud rate at which the X300 will communicate with the GPS and the
XP200 GSensor (when using both a GPS and the XP200 the baud rate must be the same). A reboot of
the X300 may be required when changing the baud rate in order to detect the GPS unit.
STATUS indicates whether or not a GPS unit has been detected. The status will be DISCONNECTED if
not unit is detected, TRACKING SATELLITES if connected but no GPS lock has been established yet
and if CONNECTED, GPS data/coordinates will appear.