SS-OCT System Base Unit
Chapter 1: Introduction
Page 2
MTN013142-D02
1.1.
Safety
SHOCK WARNING – HIGH VOLTAGE
Before applying power to the system, make sure that the protective conductor of the three-
conductor mains power cord is correctly connected to the protective earth contact of the socket
outlet. Improper grounding can cause electrical shock resulting in severe injury or even death.
Make sure that the line voltage rating agrees with your local supply and that the appropriate
fuses are installed. Fuses should only be changed by qualified service personnel. Contact
Thorlabs for assistance. Do not operate without cover installed. Refer servicing to qualified
personnel.
ATTENTION
Do not obstruct the air-ventilation slots in the computer housing. Do not obstruct air-ventilation
into the bottom of the base unit or out of the exhaust fan on the rear of the unit.
Mobile telephones, cellular phones, or other radio transmitters are not to be used within the
range of three meters of this unit, since the electromagnetic field intensity may exceed the
maximum allowed disturbance values according to IEC 61000-6-1:2005.
The safety of any system incorporating the equipment is the responsibility of the assembler of
the system.
If equipment is used in a manner not specified by the manufacturer, the protection provided by
the equipment may be impaired.
LASER RADIATION WARNING
Laser emission may be emitted
a) from the scan lens of a scanner (intended use)
b) from the back of the base unit when the fiber cap is removed and the fiber disconnected
c) from the output of the fiber when the fiber is not connected to a scanner
Do not look into the optical output when the device is operating. The laser radiation is not visible
to the human eye and can cause serious damage to your eyesight.
The laser class information is also stated on the laser safety labels on the back of the housing.
Example given for class 1M LASER product:
INVISIBLE LASER RADIATION
DO NOT STARE INTO BEAM OR VIEW
DIRECTLY WITH OPTICAL INSTRUMENTS
CLASS 1M LASER PRODUCT
CLASSIFIED ACCORDING TO DIN EN 60825‐1:2014
