SS-OCT System Base Unit
Chapter 2: Setup
Rev A, December 17, 2018
Page 11
7)
Attach the electric connection cable to the base unit
Align the red dot upwards, facing the alignment mark in the base unit.
Push the connector into the plug until a “click” sound is heard.
Figure 10
Installing the Scanner Connection Cable at the Base Unit
8)
Fiber connection to the base unit:
ATTENTION
When installing the fiber, make sure that the fiber tip does not get contaminated by dust.
Do not touch the fiber tip!
Remove the dust caps from the fiber end and from the FC/APC fiber connection at the base unit.
The fiber should be installed in a similar fashion as at the scanner. Follow the steps indicated in
Figure 9 and make sure not to touch the fiber tip.
ATTENTION
The fiber is slightly longer than the interconnection cable to avoid stress to it. Please be careful
not to pull the loop of the fiber at the back of the base unit!
Figure 11
Fiber Connection to the Base Unit
