THORLABS CLD101 Series, Руководство по эксплуатации

Страница: 73 / 92

© 2018 Thorlabs
6 Appendix
71
Specification CLD1011LP Front Panel* Remote Control*
Current Control (Constant Current Mode); CG
Control Range 0 to 1.0 A
Compliance Voltage >8 V
Resolution 100 µA 50 µA
Accuracy ±(0.1% + 500 µA)
Noise and Ripple (10 Hz to 10 MHz, rms, typ.)
w/o Filter
with Filter
(Load 4.7
W)
10 µA
5 µA
Drift, 24 hours (0-10 Hz, typ.,
at Constant Ambient Temperature)
<50 µA
Temperature Coefficient <50 ppm/°C
Current Limit
Setting Range 1 mA to 1.0 A
Resolution 100 µA 50 µA
Accuracy ±(0.12% + 800 µA)
Photodiode Input (CG or AG, switchable)
Photo Current Measurement Ranges 2 mA / 20 mA
Photo Current Resolution 100 nA / 1 µA 70 nA / 700 nA
Photo Current Accuracy ±(0.08% +0.5 µA) / ±(0.08% +5 µA)
Photodiode Reverse Bias Voltage 0.1 to 6 V
Photodiode Input Impedance ~0
W
(Virtual Ground)
Power Control (Constant Power Mode)
Photo Current Control Ranges 0 to 2 mA / 0 to 20 mA
Laser Voltage Measurement
Resolution 1 mV 400 µV
Accuracy ±(1% + 80 mV)
Laser Overvoltage Protection
Trip Voltage (typ.) 8.2 V
Modulation Input
Input Impedance 10 k
W
Input Voltage; max.
CC Mode
CP Mode ±7 V
±10 V
Small Signal 3dB Bandwidth, CC Mode
w/o filter
with filter DC to 300 kHz
DC to 9.0 kHz
Modulation Coefficient, CC Mode 150 mA/V ±5%
Modulation Coefficient, CP Mode
Photo Current Range Low
Photo Current Range High 200 µA/V ±5%
2 mA/V ±5%
RF Input
RF Input Impedance 50
W
Small Signal 3 dB Bandwidth 200 kHz to > 1 GHz
Maximum RF Power 500 mW
*) Via front panel the resolution is limited by the display. Via Remote Control a higher resolution is offered.
**) Control range and thermal stability depend on thermistor parameters and operating point.