THORLABS CLD101 Series, Руководство по эксплуатации

Страница: 13 / 92

© 2018 Thorlabs
2 Operation
11
2. Remove the 2 screws, fixing the laser mount to the
CLD1015 (marked red), using the attached 2.0 mm
Allen wrench.
3. Remove the laser mount and install it according to the
type of pinout - the arrow for the package type should
line up with the round marker (see green marking). The
picture shows the installation of the laser mount for a
standard pump laser.
4. Fix the laser mount to the enclosure. Open the ZIF
("Zero Insertion Force") socket clamps by pressing
down the lids and sliding the release levers into the
shown direction (marked blue).
5. Install the laser diode into the ZIF socket:
·
Make sure, the laser pin numbering matches with
the imprint on the laser socket. Please refer to the
laser diode's data sheet for location of pin #1.
·
Insert the laser into the mount in such way, that the
pins fit easily into the slots of the ZIF socket.
·
For laser diodes with high heat load use the
delivered thermal conductive pad to improve thermal contact between laser and heat sink.
·
Fix the laser diode to the laser mount using the attached 4 screws M2 x 5 and the 1.5 mm
Allen wrench. In order to ensure the best thermal contact between the bottom plate of the
laser diode (hot side of the laser's TEC) and the surface of the laser mount, it is
recommended to use thermal compound - particularly in case of a high laser power.
·
Close the clamps of the ZIF socket.