P12
maInmEnU
7.1Installation
This menu allows you to change satellite settings and to search for channels. Further you can
adjust important settings for your receiver. It consists of the following sub-menus:
Antenna
Setup
,
Channel Search
,
System Settings
,
Parental Lock
and
Factory Reset
. Choose a sub
menu with
pq
and press
ok
to advance.
7.1.1antennasetup
Use this menu to change or add the settings for an already installed or new satellite and to
configure its parameters. In the
Type
line you can adjust if you’re using a DiSEqC switch or not
by using
tu
to change. If your setup differs you can adjust
DiSEqC OFF
or use default setting
DiSEqC 1.0
.
Is
DiSEqC OFF
used you will only be able to setup one satellite. Press
ok
to open the settings
for this connection.
For the usage with
DiSEqC 1.0
you can enter the same parameters for up to 4 satellite
positions.
If you like to receive more satellites, you can have a motor that turns you satellite dish installed.
Select usage of
DiSEqC 1.2
or
GOTO-X
motor support and enter the same parameters for up
to 32 satellite positions. For set up and installation of this dish with motor, we advise to contact
your local dealer and ask his experience and expertise.
Editlnb
Satellite
: Press
ok
to open the list of available satellites and chose the desired one
with
pq
or
Pg±
.
LNB Type
: Choose the desired LNB Type via the
tu
buttons if you are not using a
“Universal” LNB.
LNB Low Freq.
: This shows the value for the appropriate LNB Type used and you can only
adjust for “Normal” LNB.
LNB High Freq.
: This shows the value for the appropriate LNB Type used and you can only
adjust for “Normal” LNB.
22KHz Tone
: This setting for AUTO should not be changed, only in case it is necessary
for your LNB type.
LNB Power
: Here you can change the LNB power via
tu
in case it is necessary.
Transponder
: Press
ok
to open the list of available transponders for the chosen
satellite, in order to check your reception or align the antenna.
After all settings are adjusted following to your system requirements, choose
Save
with
pq
or
Cancel
to discard changes and press
ok
. The receiver will return to the selection screen and
you can continue.
In case you want to delete a desired satellite press the
gREEn
button. If you want to delete all
satellites that have been setup use the
YElloW
button to do so. Once all settings are made,
press
EXIT/soRTIE
to change to the previous menu.
7.1.1.1DisEqC1.2set-up
In this menu you can set up the motor position which you like to receive for every satellite if you
use the dish with a DiSEqC 1.2 motor. Select a position number and press
ok
to open the list
of available satellites and chose the desired one with the
tu
buttons.
Movement Speed
: Here you can change the speed of movement. (Slow/Quick)
Move
: Press
tu
to turn the dish to East or West. Turn until you see a signal on
both signal bars levels. Then you have found the selected satellite. Then
press
EXIT/soRTIE
and select
Yes
to store and confirm the position
when you have found the wanted satellite.
Center Position
: Press
ok
to turn the motor to the central position of 0 degrees. This is
only needed 1 x time to adjust the dish the first time.
