P8
sTaRTIngUPfoRThEfIRsTTImE
When all settings have been made, press
blUE
Next
to continue.
To check or change the settings for the satellite on port 1 press
ok
to enter the submenu. If
port 1 is already correctly adjusted and you have proper signal quality and strength banners you
can adjust the port 2 if you have a satellite connected there. Use
pq
to select it and proceed
like below chapter describes. This you can do for up to 4 satellite positions.
4.3.1Editlnb
In this submenu you can adjust following parameters:
Satellite
: Press
ok
to open the list of available satellites and choose one with
pq
or
Pg±
.
LNB Type
: Choose LNB Type with
tu
if you are not using a “Universal” LNB.
LNB Low Freq.
: This shows the value for the appropriate LNB Type used and you can only
adjust for “Normal” LNB.
LNB High Freq.
: This shows the value for the appropriate LNB Type used and you can only
adjust for “Normal” LNB.
22KHz Tone
: This setting for AUTO should not be changed, only in case it is necessary
for your LNB type.
LNB Power
: Here you can change the LNB power with
tu
if necessary.
Transponder
: Press
ok
to open the list of available transponders for the chosen satellite
in order to check your reception or align the antenna.
After all settings have been adjusted according to your system requirements, choose
Save
with
pq
or
Delete
to discard changes and delete the satellite from the settings. Press
ok
. The
receiver will return to the selection screen and you can continue by pressing the
blUE
Next
button.
4.4scanselection
In the
Scan Mode
you can choose
Fast Scan
which quickly installs all channels from the
operator and
Full Scan
to first scan with
Fast Scan
and then all frequencies from the selected
satellite(s).
In
NIT Search
you can select
ON
if you want to scan for newly appeared channels/
transponders or
OFF
if you don’t like to.
This is only working if you do a
Full Scan
. We recommend setting the scan mode with the
Fast
Scan
. In this mode all goes automatically. After everything is setup following to your preference,
choose the
blUE
Next
button.
In the next appearing screen you can select the channel list you like to have loaded into your
receiver. Use
pq
to highlight your selection in orange colour. Press
ok
to choose a list and
the receiver will start the scan process directly. Please, have a moment patience as this will take
some time.
noTE:
Once you have selected the FST channel list you prefer, the receiver will always automatically
reload/adjust this list later. If you like to change to another list you must do a Factory Reset
and start complete new (see chapter
7.1.5
.)
The receiver will perform the chosen scan process. Afterwards all found channels will be stored
and the receiver will switch to the first found channel or the first channel.
noTE:
If the dish is pointed out to a wrong satellite or if there is no or too low signal from the
satellite dish, the receiver cannot install channels and will return to the beginning of the First
Installation. Please, first check the cables, the direction of the dish and the settings and try
scanning again.
The channels from the operator will be stored from nr.1 up to nr. 3999 in the FST list. All other
channels will be stored from channel nr. 4000 and upwards.
