1226 R830000-1060
XDS Pro Quick Start Guide
1/11/2010
Rev H
Page 1 of 11
X-Digital Systems XDS-PRO receiver
QUICK START GUIDE
REVIEW THIS GUIDE IN ITS ENTIRETY BEFORE INSTALLING
YOUR XDS RECEIVER. ALSO, FOLLOW THESE INSTRUCTIONS
BEFORE CALLING SUPPORT.
XDS urges stations to use an Uninterruptible Power Supply
(UPS) for the XDS receiver for equipment protection from
power spikes or brownouts. Also consider lightning protection
if you are located in an area susceptible to frequent lightning
storms. Surge suppressors do not provide sufficient protection.
NOTE: Use the included “Network Configuration Data Sheet” to
properly activate your receiver on the desired network.
NOTE: Appendix A contains a front panel menu map that can help
you navigate through the XDS receiver settings and configuration.
1. MAKING THE CONNECTIONS
Satellite RF, data (LAN/WAN) and audio must be properly
connected. Please follow the steps below:
1.1 SATELLITE RF CONNECTION
Your XDS receiver is pre-tuned to you network‟s carrier as specified in the attached
“Network Configuration Data Sheet”. Once the satellite RF is properly connected and
you apply AC power, the XDS receiver should automatically tune and lock to the
network‟s carrier.
A.
Connect the satellite RF to your downlink
Your receiver will NOT receive network programming, until you
connect your XDS receiver to the internet and Activate it per the
instructions in this document. Your XDS receiver MUST be
connected to the internet AT ALL TIMES.
