THOMSON CIM 3.0, Руководство пользователя

Страница: 27 / 81

SECTION 2 THS 2000 SOFTWARE PROGRAM
PM055 Rev 2 00/08/31 Thomson Technology
21
Clicking on the Connect button will begin the connection process. If you experience
problems connecting to the remote site, please refer to the troubleshooting section of
this manual.
See Connecting A Site .
2.6. Step 6: Identify Controllers
Once you are connected to the remote site, you need to identify the controllers on the
site. If you are running CIM 3.0 or higher, the THS 2000 software will offer the controllers
that have already been discovered, as shown below. You merely need to accept the
controller list to have them added to the site. If you are running an older CIM, you must
identify and add the controllers manually; see the Adding A Controller section later in this
manual.
At this point, you are connected and communicating with the CIM and its controllers. The
status bar at the bottom of the window will flicker and display a message similar to
"Connected to EastWing."
2.7. Step 7: View Controller Data
A set of buttons at the top of the window will contain the word List and the number of
each controller. This is the Controller Bar. Clicking a button on the Controller Bar selects
the current view in the main part of the window. The list-view is a list of all the controllers
and the controller views are representations of an individual controller.
When the selected site is connected, the dot in the middle of the controller bar button will
indicate the status of the controller (green, yellow, red or black).
See Controller Views .
2.8. Step 8: Issue Controller Commands
Once connected to a site, commands can be issued to controllers through the Mec20
Command or Tsc800 Command menu items under the Controller menu.
See Controller Commands .