Thompson ViBE EM4000, Руководство пользователя

Страница: 39 / 350

Chapter 2 ’Installation and Startup’ — Performing the Initial Settings
ViBE EM4000 — Release 1.10 27
User Manual — 46073586AB02
Figure 2-7. Control 1 connector, ViBE EM4000 NEM40IN2AA rear panel
As the ViBE EM4000 Control Ethernet interfaces host an autocrossover
mechanism, you can use a direct or crossed cable connection between
the PC and ViBE EM4000.
SSH client application setting
The SSH client application must be set with the following parameters:
™ Host name (or IP address) :
Encoder IP address
™
Port :
22
Accessing the Local Console
1. Run the SSH application on the PC connected to the network using the
Encoder IP address. The Login page is displayed.
2. Enter
user
as Login
Figure 2-8. Enter login, Login page
3. Enter
user
as password
The Local console main screen is displayed:
„
The ViBE EM4000 IP address, which is required for the first
connection, is given on the Acceptance Test Report shipped
with the device.
„
The factory set IP address and Netmask for the Control &
Command port are 192.168.1.1 and 255.255.255.0.
„
The Encoder IP address can be viewed/edited via the Encoder
Front panel. Refer to section
’IP Settings screen’ on page 45.
„
The IP address can be changed during the installation setup (see
section
’Editing IP parameters (ipset)’ on page 29) or via the
Encoder Front panel. Refer to section ’IP Settings screen’ on
page 45.
This IP address will be the new customer set IP address that will
be required for subsequent connections to the device.
Control 1