Thompson ViBE EM4000, Руководство пользователя

Страница: 58 / 350

Chapter 3 ’Front Panel Operation’ — Screen Description
46 ViBE EM4000 — Release 1.10
User Manual — 46073586AB02
™ Use the
Í
and
Î
keys to select the field to be modified and then
use the
Ð
and
Ï
keys to adjust the value. Refer to figure below:
Figure 3-11. IP Address, Settings screen
™ Confirm the new value by pressing OK. The Confirm screen will
be displayed:
Figure 3-12. IP Address settings, Confirm screen
™
Press OK to enable the new IP address or press ESC/HOME to
exit this screen.
Recall screen
The Recall screen is used to recall a predefined configuration.
Configurations are predefined via the Web Interface. To define
configurations, see section
’Predefined Configurations’ on page 99. To
display the Recall screen, go to the Setup screen, select RECALL using
the
Í
and
Î
keys and press OK.
Figure 3-13. Recall screen
IP Address
0 1 0 1 4 1 . 1 2 7. 0 4 0
0 1 1 1 4 1 . 1 2 7. 0 4 0
IP Address :11.141.127.40
Do you Confirm update
No=ESC Yes=OK
„
The consistency between the IP address and Gateway address is
checked. If an error is detected a
Bad value message can be
displayed. The Gateway address can also be resetted.
„
The changes will be acknowledged after the Encoder has been
rebooted.
RECALL XX/YY
ÏÐ
ZZ EQU: ------------------
> ZZ EQU: ------------------
ZZ ENC: ------------------
ZZ ENC: ------------------
XX/YY XX indicates the number of the currently selected
predefined configuration. YY indicates the total number
of predefined configurations.