Theta Digital Casablanca II, Руководство пользователя

Страница: 97 / 125

87
The current delay settings will be displayed on the video monitor. All
delay settings apply to all
MODE s, however they can be further
manipulated when the current MODE is either Dolby Digital, DTS or
Circle Surround, via additional Setup sub menus for these MODE s.
Select each speaker one at a time and adjust the individual delay
according to the detailed information and graph on page 58
.
The speakers in these menus may vary from the user’s, depending on
which DAC channels are installed as well as which ones are set to be
active. (If a speaker set is turned
OFF via the SPEAKER CONFIG sub
menu, it will not be displayed in these sub menus).
Figure 83 - Video Display of the SETUP/INPUT/DELAYS 2 Sub Menu
When all speaker delays have been set, press SET-UP once to return to the SETUP / INPUT page 1 sub menu, or
SET-UP three times to return to the main INPUT SELECT menu.
Default Mode
Each INPUT SELECT button can have a different default MODE assigned to it. To assign a default MODE for a
given INPUT SELECT button, first press the applicable INPUT SELECT button, SETUP , INPUT then button # 4
( MODE ). Edit this parameter to select the desired default MODE , then press SETUP twice to exit. Repeat this
procedure for each
INPUT SELECT
button.
Note : Pressing the front panel MODE function button allows the user to audition different modes for a given source,
when applicable, however changing modes via the
MODE
button does not store a mode selection.
Onscreen Display (OSD) Setup
Pressing SETUP , ACTIVE INPUT SETTINGS , then ON-SCREEN DISPLAY button # 5 activates the On-Screen
(OSD) set up menu, shown in figure 84.
In this display, button # 1 ( BACK COLOR ) allows the user to select up to 7 different OSD background colors. The
entire OSD can be offset from the left and top edges of the screen (button #’s 2 and 3 respectively) to accommodate
differences in monitors.
The configuration (
CONFIG ) feature (button # 4 ) can switch the Casablanca II’s OSD to accommodate either an
NTSC or PAL monitor.
The configuration ( CONFIG ) feature (button # 4 ) can switch the
Casablanca II’s OSD to accommodate either an NTSC or PAL monitor.
When a function button is pressed, its OSD will remain on the screen
until the user is no longer in any function menu. The
DISPLAY TIME
(in seconds) setting (button # 5 ) allows the user to set the amount of
time (delay) that the video monitor displays the INPUT SELECT menu,
when changing inputs.
Button #
6 allows the user to decide which parameters will show on the
STATUS page as well as their placement on the screen. This feature
is discussed next.
Figure 84 - Video Display of the SETUP / INPUT Page 3 / ON-SCREEN DISPLAY Sub Menu
Status Setup
STATUS SETUP (button # 6 ) displays a sub menu, which allows the user to change the position of the Status screen
text on the video monitor only. The first Status Setup sub menu is shown in figure 85.