22
Speakers in a typical 12 channel system
Dolby Digital, DTS and Circle Surround Setup
The center and left/right surround speaker levels and delays will most likely differ for Dolby Digital and DTS sources, as
well as when the Mode is Circle Surround. There are separate
SETUP
submenus designed just for these modes.
When the mode is Dolby Digital, DTS, or Circle Surround, the center and surround delays will work together with
changes made in the above
DLYS
submenu. Likewise, the values of the levels set in the Dolby Digital, DTS and Circle
Surround setup submenus will be added to (or subtracted from) the level values in the
SETUP
/
INP
/
LVLS
submenu.
12)
a) Play a Dolby Digital movie.
b) Go to the Dolby Digital setup submenu – page 2.
c) Set the center speaker delay to the same value as in the
SETUP
/
INP
/
DLYS
submenu.
d) Set the surround delay 15mS less that those set in the
SETUP
/
INP
/
DLYS
submenu.
e) Set the center speaker level and the surround speaker level to 0. Please refer to the
SETUP/Dolby Digital
section of the Owner’s Manual for additional information regarding setting the Dolby Digital center and
surround levels.
f)
The
LFE
setting should NOT be turned
OFF
if no sub woofer exists in the system. A setting of
0
turns on the
LFE
and sets its level in proper proportion to the remaining 5 channels. Setting the
LFE
at
–10
[dB] may be
desired for late night viewing or if source material may overpower the sub woofer. Setting the
LFE
to
OFF
may be useful for late night viewing, however, please note that any information in the .1 channel will be lost.
Remember that these values will be in effect only when the
MODE
is Dolby Digital.
13)
a) Play a DTS encoded CD or movie.
b) Go to the DTS setup submenu.
c) Set the center speaker delay to the same value as in the
SETUP
/
INP
/
DLYS
submenu.
d) Set the surround delays 15mS less that those set in the
SETUP
/
INP
/
DLYS
submenu.
e) Set the center speaker level to
0
.
f) Set each surround speaker level to
0
.
g)
Set
the
LFE
level at
0
for DTS movies, or
-10
for DTS music. (The user can choose to use two separate
input select buttons, one for DTS movies and one for DTS music, all parameter values being the same
except for the LFE setting).
These parameter values apply only when the
MODE
is
DTS
.
14)
a) Play a 2 channel CD.
b) Go to the Circle Surround setup submenu.
c) Set the center and surround speaker delays to the same value as in the
SETUP
/
INP
/
DLYS
submenu.
d) Set the center speaker level and each surround speaker level to 0.
e) Set the imaging to
NARROW
or
WIDE
, applicable only when the mode is Circle Non-Encoded.
WIDE
widens the speaker imaging in the front [left/right] speakers.
These parameter values apply only when the
MODE
is any one of the three Circle Surround modes.
Remaining Setup
15) Now that the speaker configuration, crossovers, levels and delays have been set up for input select button #1, they
should be copied to all input select buttons as a good starting point. Do this in the
MACROS
submenu when input
Содержание Casablanca II
