Thermo Scientific Thermo Scientific SL16, Инструкция по эксплуатации

Страница: 32 / 62

4
Operation
Temperature adaptation during standstill
4-8 SL 16 / 16R Thermo Scientific
Temperature adaptation during standstill
The temperature cannot be adapted until the rotor has been positively identified; the speed display
will then show "END".
When the rotor is not recognized (lid closed and START key not yet pressed, speed display "0"),
the centrifuge responds by ensuring that the sample cannot freeze regardless of the rotor being used.
Short-term centrifuging
For short-term centrifuging, the Thermo Scientific SL16 / 16R has a "Pulse"- function.
By holding down the PULSE key , spinning will start and continue until the key is let go.
The centrifuge accelerates and brakes at maximum power. Any rpm or RCF entered beforehand is
overridden.
Check carefully whether you have to maintain a certain speed for your application.
During the acceleration process, time is counted forwards in seconds. The reading stays displayed
until the centrifuge lid is opened.
Removing the rotor
To remove the rotor, proceed as follows:
1. Open the centrifuge lid.
2. Grab the rotor handle with both hands and press against the green AutoLock
TM
key. At the same
time, pull the rotor directly upwards with both hands and remove it from the motor shaft. Make
sure not to jam the rotor while doing this.
Note The centrifuge accelerates to maximum speed, regardless of which rotor was installed.