Thermo Scientific SHKE8000 Series, Руководство по обслуживанию

Страница: 13 / 106

Before installing the single unit onto the stand, place the stand in its final
location.
1. Install the neoprene pads to each of the stand leveling feet.
2. Place a 1-1/2 inch tall spacer over each hole on the top four corners of
the stand.
3. Remove the (4) leveling feet from the shaker.
4. Carefully lift and position the shaker over the spacers on the stand.
Align the (4) mounting holes in the bottom of the shaker with the (4)
spacers.
5. Assemble the lockwashers, then the D-shaped flatwashers onto the
1/2”-13 x 4” bolts. Thread the bolts through the underside of the
stand top rails, through the spacers and into the holes in the bottom of
the unit. Tighten these bolts to secure the shaker to the stand.
6. Level the stand. Refer to the Leveling section.
1-4 Model SHKE8000 Series Shakers Thermo Scientific
Section 1
Installation
Single Unit on a Stand
top left corner
of stand
4 in. bolt
bottom left corner
of shaker
1 in. spacer
D-Flatwasher
Lockwasher
Figure 1-8. Shaker to Stand
Figure 1-9. Unit on Stand