Thermo Scientific SHKE8000 Series, Руководство по обслуживанию

Страница: 22 / 106

An internal, remote alarm SPDT relay is provided to monitor alarms and
is connected by an RJ-11 (telephone style) jack, located on the lower left
front corner of the cabinet, behind the kick panel. The relay provides NO
(normally open) and NC (normally closed) output and may be wired to a
central remote alarm location or to an independent alarm system.
Figure 1-21 identifies the pin contacts. Figure 1-20 shows the location of
the Remote Alarm Connector.
A modular to modular cable, Stock No. 190388 and an RJ-11 telephone
style terminal converter, Stock No. 190392 or equivalent may be used to
convert to a screw terminal connection. Refer to Figure 1-22.
Connect the line cord to the power inlet on the back of the unit. Route
the cord through the factory-installed tie wrap anchor and tie wrap into
place. This avoids accidental disconnection of the power cord from the
unit.
See the serial tag on the side of the unit for electrical specifications or refer
to the electrical schematics at the end of this manual.
Caution Connect the orbital shaker to a grounded, dedicated circuit.
The power ON/OFF switch is the mains disconnect device for the orbital
shaker. Position the unit so the switch is easily accessible.
s
Model SHKE8000 Series Shakers 1-13 Thermo Scientific
Section 1
Installation
Connect the Remote
Alarm
Figure 1-22. Converter
Connect to Electrical
Power