Thermo Scientific SHKE8000 Series, Руководство по обслуживанию, Страница: 16 / 106

A 3/8” O.D. stainless steel condensate drain is located on the right side of
the shaker in the side car (Model SHKE8000-7/SHKE8000-8CE only).
This drain removes any water which may collect in the air ductwork.
Water accumulates into a pan where it is evaporated by the heat from the
refrigeration system. This drain does not require maintenance.
Each flask clip up to 2.8 liters in size comes with a metal spring which
must be installed onto the clip. For flask clips through 500 ml, insert the
end of each spring into the holes on the top of the clip leg as shown in
Figure 1-15.
The 2.0 and 2.8 liter Flask Clips use two metal springs and rubber spring
tubes. On the larger clip, the springs are installed by hooking their ends
together as illustrated in Figure 1-16. The upper spring and spring tubes
should be installed prior to mounting the clip to the platform. The lower
spring and spring tubes however, are placed around the bottom of the clip
legs after the flask clip is fastened to the platform.
The 2 and 2.8 liter clips are supplied with two sets of springs and rubber
tubes.
Note that rubber spring tubes are placed between each clip leg.
Model SHKE8000 Series Shakers 1-7 Thermo Scientific
Section 1
Installation
Condensate Drain
Assemble the Flask
Clips
Figure 1-15. Clip Assembly Figure 1-16. For Liter or Larger Flasks