Thermo Scientific SHKE8000 Series, Руководство по обслуживанию

Страница: 57 / 106

4-2 Model SHKE8000 Series Shakers Thermo Scientific
Section 4
Service
Change the Chamber
Air FIlter
The chamber air filter is located on the left side of the chamber and is
accessed by first removing the endplate. Eight screws secure the endplate
and filter assembly to the chamber wall. Refer to Figure 4-1 below.
Remove the three screws from each end of the filter assembly first. Set the
screws and endplate aside. Then remove the top and bottom screws from
the filter and discard the filter.
To install the new filter, secure the filter first at the top and bottom with
the two screws. Then secure the front edge of the filter with the three
screws and the far end with the endplate and screws as above.
If the shaker platform will not operate with the unit plugged in and the
power switch turned on, the following conditions may be present:
• The door may be open - Lift the door to its fully closed position.
• Time countdown reached - Reset the time, or change to continuous
operation (Hold).
Figure 4-1. Filter Location
If the Shaker Will Not
Operate