Thermo Scientific SHKE8000 Series, Руководство по обслуживанию

Страница: 55 / 106

3-2 Model SHKE8000 Series Shakers Thermo Scientific
Section 3
Maintenance
Platform Handle
Adjustment
1. Grasp the platform handle and pull up on the inner release bar to
move the handle to a horizontal (down) position.
2. Remove the screws from the sides of
the handle, as indicated in Figure 3-
2. Remove the handle.
3. Turn the adjustment screws just one-
half turn clockwise to increase the
clamping force, or one-half turn
counterclockwise to reduce the
clamping force.
4. Reassemble the handle and install the side screws. Slide the platform
into the shaker chamber. Place the handle into a vertical position.
5. Close the door and run the unit empty, at 300 RPM. If there is undue
vibration noise, repeat the steps above. If not, return the unit to
service.
The microprocessor control panel uses sealed push buttons and liquid
crystal display and may be cleaned with laboratory detergents and dried
with a soft cloth.
The condenser air filter (P/N 760202) is located behind the grille on the
front of the sidecar (Model SHKE8000-7/SHKE8000-8CE). The grille is
secured by four press-in type retainers at the top and bottom. Remove it by
grasping the edge of the cover and pulling
outward.
The air filter is held in place with a flange
around its perimeter (Figure 3-3) and is
easily removed. It may be replaced, or
washed in water with a mild detergent and
dried between two lint-free towels.
Figure 3-2. Screws
Control Panel
Clean/Replace
Condenser Air Filter
Figure 3-3. Inside Front Grille