Thermo Scientific LevelPRO Series, Инструкция по применению

Страница: 76 / 99

LevelPRO Specific Parameters
Parameter Tab Type R/W Description
BAD_FLAGS_1 (cont.) Others BF R Bad flags set 1
Bit 6 – “Cal is not real” Bit 22 – “Number of Break Points >
16”
Bit 7 – “Cal-Std ratio value
too low”
Bit 23 – “Data Testing suspended”
Bit 8 – “Cal-Std ratio too
high” Bit 24 – “Max Volume required but
not entered”
Bit 9 – “Unused” Bit 25 – “Unused”
Bit 10 – “Standardization
detector count too low” Bit 26 – “Unused”
Bit 11 – “Cal value too low” Bit 27 – “Tank Vol Setup too
complex”
Bit 12 – “Unused” Bit 28 – “Unused”
Bit 13 – “Unused” Bit 29 – “Window Code must be
greater than 0”
Bit 14 – “Unused” Bit 30 – “Transmit update time must
be > 19”
Bit 15 – “Invalid Days/week” Bit 31 – “Master Unit has no update
time”
BAD_FLAGS_2 Others BF R Bad flags set 2
Bit 0 – “Unused” Bit 5 – “Brktab Range Error”
Bit 1 – “Unused” Bit 6 – “Unused”
Bit 2 – “No Rate Channel
specified” Bit 7 – “ Xray Safeguard Min Hold is
> Max”
Bit 3 – “Measurement # for
rate must BE < 1” Bit 8 through Bit 31 – “Unused”
Bit 4 – “Unused”
CAL_POINT_TO_BE_PROCESSED Others CAL R/W Select the point to be calibrated.
CAL_POINT_USED Others CAL R/W This parameter is normally set by the device. It indicates the number
of calibration points being used. You may set the value to a lower
one if necessary.
CAL_STD_RATIO_POINTX
(POINT1 through POINT10) Others CAL R/W The calibration/standardization ratio for CAL points 1 through 10.
CAL_X_TIME_CONST Others CON R/W Specify the number of time constant periods to be used for the
calibration cycle.
COUNTDOWN_TIMER Others S R The time left to complete standardization or calibration in seconds.
DETECT_SIG_VALUE Others S R The internal value of the detector signal.
HIGHEST_CALED_POINT Others CAL R The number of points for which calibration data exists.
C-6 LevelPRO with F
OUNDATION
™ fieldbus Application Guide Thermo Fisher Scientific