Thermo Scientific iCAP RQ ICP-MS, Руководство по требованиям предварительной установки

Страница: 70 / 71

Please note instrument type: iCAP RQ - 1-channel instrument
iCAP RQ - 2-channel instrument
1. Yes No All laboratory remodeling has been completed and the space available is sufficient to meet the minimum
requirements for the configuration ordered? The floor is certified to meet the load requirements of the system?
2. Yes No Your instrument has been delivered and is either in the laboratory or can be delivered immediately on the
arrival of the installation engineer?
3. Yes No The key operator will be available during the installation period. The person with the authority to accept the
instrument at the end of the installation will also be available to sign the required acceptance document?
Please provide the names of these individuals:__________________________________________________
4. Yes No The entrance to the laboratory and the route from the loading dock are at least 90 cm (36 in.) wide with
additional space at corners?
5. Yes No Sufficient bench space is available for all of the equipment? List the following:
Width: ____________________, Depth: _____________________, Height: _______________________
6. Yes No Workbench can support the load of the system including optional equipment and is free from vibration?
7. Yes No Main power is installed and in compliance with local electrical codes?
Note the type of cables required for your area:__________________________________________________
8. Yes No The power outlets are of the correct configuration?
9. Yes No The electrical power for instrument and fore vacuum pump and has been measured?
Please note voltage (instrument): _____________________ Volts AC line to ground.
Please note voltage (fore vacuum pump): _______________ Volts AC input to neutral.
10. Yes No Additional power outlets are available for the fore vacuum pump and other peripherals?
11. Yes No Air conditioning is adequate for temperature, humidity, and particulate matter control? The laboratory can be
maintained at a constant temperature, between 15 and 35 °C (59 and 95 °F)?
12. Yes No The relative humidity is between 20% and 80%, non-condensation and non-corrosive atmosphere?
13. All gases required are on site, gas lines are installed, and appropriate gas regulators are available?
List gases and purity: _________________________________________________________________
14. Yes No A hydrogen gas sensor is installed? (iCAP RQ 2-channel instruments)
15. Yes No Is there is a suitable exhaust system present that is separate from solvent waste? You must provide one exhaust
system for the instrument heat exhaust and the plasma exhaust system.
16. Yes No Provision has been made for collecting solvent waste? A suitable waste container is provided?
17. Yes No There is a functional telephone close to the system? Phone number ______________________________
18. Yes No All required chemicals and equipment for installing the system are on site?
19. Yes No Have any special acceptance specifications been agreed within the contract?
If YES , please attach full details of specification.
20. Yes No Is there any additional equipment that needs to be interfaced for the system?
If YES , please supply details.
iCAP RQ ICP-MS Installation Request Form
Please refer to the iCAP RQ ICP-MS Pre-Installation Requirements Guide (P/N BRE0009927) for the complete site
requirements. Circle “Yes” or “No” as to whether the site meets the requirements as specified in the Preinstallation Guide.
Provide the additional information where requested.
Thermo Scientific P/N BRE0009927, Revision A
I
,
the undersigned, confirm that the site requirements as stated above have been accomplished and the laboratory is prepared for the
installation of the instrument. I understand that I may be liable for a Field Service Representatives’ travel or lodging expenses if they
are unable to carry out the installation on the pre-scheduled date due to insufficient lab preparation. If circumstances warrants,
Thermo Fisher Scientific will make every effort to reschedule an installation as soon as possible with the next available representative.
Signed: ________________________________________ Print Name: ____________________________________________
Company name: _________________________________ Email: ________________________________________________
Date: _________________________________________ Phone:
________________________________________________
Fax to : Attn: Local Service Engineer
Note After we receive this checklist, your local Field Service Representative will contact you to schedule installation.
▲