Thermo Scientific AutoWAVE 1-0479-013, Руководство пользователя

Страница: 13 / 44

Document 1-0479-013 Rev B
7
3.1 (0) Set Operation Mode
When item (0) is selected the Operation Mode appears as shown in figure 2. The Operation Mode
option is used to designate the method in which the particular AutoWAVE Transceiver will be used.
AutoWAVE operates in a master to slave configuration; therefore, any transceivers which are
intended to operate together must be set up as such. In a Point-to-Point setup, either the master or
slave may be used on either end of the communications link without any performance degradation.
One consideration when setting up the transceivers is that a number of parameters are controlled by
the settings in the master; therefore, you may wish to deploy the master on the communications end
where you will have easier access to the transceiver.
MAIN MENU
Version 5.31 05-31-97
Standard Hop Table
Modem Serial Number 900-3743
(0) Set Operation Mode
(1) Set Baud Rate
(2) Edit Call Book
(3) Edit Radio Transmission Characteristics
(4) Show Radio Statistics
(5) Edit MultiPoint Parameters
(6) TDMA Menu
(Esc) Exit Setup
Enter Choice
SET MODEM MODE
Modem Mode is 2
(0) Point to Point Master
(1) Point to Point Slave
(2) Point to Multipoint Master
(3) Point to Multipoint Slave
(4) Point to Point Slave/Repeater
(5) Point to Point Repeater
(6) Point to Point Slave/Master Switchable
(7) Point to Multipoint Repeater
(Esc) Exit to Main Menu
Enter Choice
Figure 2. Operation Mode