Document 1-0479-013 Rev B
11
set dtr on
send line “ATXD2"
send line “ATXX1"
send line “ATXT9"
send line “ATXF9"
send line “ATXR2"
send line “ATXP9"
send line “ATDT2"
end terminal
When pcANYWHERE is instructed to call a Host PC corresponding to an entry that has
been established with the above instruction, the following should occur:
‚
pcANYWHERE should go into terminal mode
‚
A series of OKs should appear in the terminal window (one OK for each line of the
script file being run). If this does not occur it is likely due to the baud rate on the
transceiver being different than the data rate set on pcANYWHERE.
‚
The word Connect will appear when the AutoWAVE transceiver has established
connection to the slave (or the first repeater if appropriate).
‚
The computer being called will appear on the screen as the connection is completed.
Figure 3: Mode 6 Script File
Script File
Function Controlled
ATXF
Frequency Key
ATXT
Max Packet Size
ATXD
Min Packet Size
ATXX
Transmit Rate
ATXR
RF Data Rate
ATXP
RF Transmit Power
ATDT
Position in Call Book
ATD_
Allows specific AutoWAVE ID Number to
be entered to call
ATXC_
Used in conjunction with the ATD command,
instructs transceivers which repeater path to
follow
ATXS
Instructs Transceiver to go into Setup Mode
Table 3. AT Script File Commands
Содержание AutoWAVE 1-0479-013
