Thermo King T-1080S, Руководство по обслуживанию

Страница: 119 / 191

Engine Maintenance
118
9. Tighten the pulley mounting nut.
10. Check the orientation of the restraining mount
(snubber) eye-bolt because the ‘eye’ is offset.
Make sure it is oriented as shown in the
following drawings.
11. Place the straight edge against the side of the
muffler can.
12. Tighten the nut on the restraining mount
(snubber) until the straight edge lines up with
the mark for the initial unloaded engine
position in step 7.
NOTE: It is important to turn the belt as the
nut is being tightened to prevent tension
from building up in the belt.
NOTE: The washer on the restraining mount
(snubber) should not go below the bracket
side wall height. If it does, the restraining
mount (snubber) will be over-compressed.
13. Check the belt tension frequency using the
frequency gauge P/N 204-1903 and adjust to
the correct tension if necessary.
14. Reinstall the electric motor (jackshaft)/
compressor belt if it was removed.
1. Orient Bulge Up
Figure 206: Eye-Bolt Orientation for TK 380 Engine
1. Orient Bulge Forward
Figure 207: Eye-Bolt Orientation for TK 374 Engine
ARA2028
1
ARA2029
1
1. Washer (Should Not Go Below Bracket Side
Wall Height)
2. Bracket Side Wall
Figure 208: Restraining Mount (Snubber)
and Bracket
1 2