Textron Stampede 900 2017, Руководство по ремонту и обслуживанию

Страница: 75 / 237

B
BRAKES
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
63
Repair and Service Manual
668061
2. Apply moderate (40 - 50 lbs. [18 - 23 kg]), steady
pressure on the brake pedal, and open the bleeder
valve.
Do not force the brake pedal to the
floor. The operating rod can be
forced into the master cylinder
where it can damage internal components.
3. If the brake pedal goes to the floorboard without
removing all of the air bubbles, close the bleeder
valve and release the brake pedal slowly. Repeat
steps 1 and 2.
NOTICE: The bleeder valve at the brake caliper must
be closed at the end of each stroke, and before the
brake pedal is released to ensure that air cannot
enter the system. It is also important that the brake
pedal be returned to the full released position.
4. When fluid coming from the submerged end of the
hose is clear and free of bubbles, close the bleeder
valve and release the brake pedal. Tighten the
bleeder valve to the maximum torque value specified
below.
.
Flushing the Brake System
The process of removing old brake fluid to remove water,
mineral oil or other contaminants from the system is
called flushing the hydraulic system.
Flushing is similar to bleeding except that a greater
amount of brake fluid is discharged from each bleeder
point to make sure that all of the dirty or contaminated
fluid is removed.
BRAKE AND ACCELERATOR PEDALS
Brake Pedal Removal And Installation
Tool List Qty.
Needle Nose Pliers ......................................................1
Socket, 9/16”................................................................1
Ratchet ........................................................................1
Wrench, 3/4” ................................................................1
Torque Wrench, ft. lbs..................................................1
1.
Disconnect the brake pedal from the master cylinder
push-rod by removing cotter pin (9) and clevis pin
(10) from the brake pedal (Ref. Fig. 9).
Fig. 9 Disconnect Brake Pedal
2. Remove pivot bolt (6), bushings (11) and lock nut (7)
(Ref. Figure 10).
3. Remove pedal.
4. Brake pedal installation is the reverse order of
removal.
5. Tighten bolt (6) and nut (5) to the torque specified
below.
Item Torque Specification
Bleeder Valve 38 in. lbs. (4 Nm)
Item Torque Specification
6, 7 18 - 22 ft. lbs. (24 - 30 Nm)
9
10