Textron Stampede 900 2017, Руководство по ремонту и обслуживанию

Страница: 25 / 237

B
SAFETY
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
13
Repair and Service Manual
668061
LIFTING THE VEHICLE
Tool List Qty.
Floor Jack.................................................................... 1
Jack Stand................................................................... 4
Chocks ........................................................................ 4
To reduce the possibility of severe
injury or death from a vehicle falling
from a jack:
Place shifter in the P (park) position.
Always place chocks in front and behind the
wheels.
Be sure the vehicle is on a firm and level surface.
Never get under a vehicle while it is supported only
by a jack.
Use jack stands and test the stability of the vehicle
on the stands.
The vehicle is extremely unstable during the lifting
process.
When lifting the vehicle, position jacks and jack
stands only on the areas indicated.
Remove payload from vehicle before lifting. No per-
son(s) should be in or on the vehicle during the lift-
ing process.
NOTICE: If under-vehicle access is required, remove
the skid plate prior to beginning the lifting process.
Lifting Front of Vehicle
1. Chock the rear wheels to keep the vehicle from roll-
ing backward (Ref. Fig. 2).
2. Put a jack under the center of the vehicle frame at
the differential mounting plate (Ref. Fig. 1).
3. Raise the vehicle with the jack.
4. Install a jack stand under each side of the vehicle
frame just behind the front wheels.
5. Lower the vehicle until it rests on the jack stands.
6. Remove the jack.
7. Confirm that the vehicle is stable on the jack stands
before proceeding with any service.
Lifting Rear of Vehicle
1. Chock the front wheels to keep the vehicle from roll-
ing forward (Ref. Fig. 2).
2. Put a jack under the center of the vehicle frame at
the hitch mounting plate (Ref. Fig. 1).
3. Raise the vehicle with the jack.
4. Install a jack stand under each side of the vehicle
frame just in front of the rear wheels.
5. Lower the vehicle until it rests on the jack stands.
6. Remove the jack.
7. Confirm that the vehicle is stable on the jack stands
before proceeding with any service.
Lowering Vehicle
1. Make sure chocks are still in place on any wheels
that remain on the ground.
2. Put the jack in the same location that was used to
raise the vehicle.
3. Raise the vehicle enough to remove the jack stands.
Remove the jack stands from underneath the vehi-
cle.
4. Slowly lower the vehicle to the ground and remove
the jack.
Fig. 1 Lifting the Vehicle
Fig. 2 Wheel Chocks
FRONT
REAR