Textron Stampede 900 2017, Руководство по ремонту и обслуживанию

Страница: 10 / 237

B
viii
Repair and Service Manual
GENERAL INFORMATION & ROUTINE MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
668061
TRANSPORTING THE VEHICLE
To prevent personal injury to occu-
pants of other highway vehicles, be
sure that the vehicle and contents
are secured to trailer.
Do not ride on a vehicle being transported.
This vehicle is not designed to be towed.
It is recommended that the vehicle be moved by placing
the entire vehicle on a trailer, flatbed truck or other suit-
able transport.
Always check that the vehicle and contents are secured
before transporting the vehicle. The rated capacity of the
trailer must exceed the weight of the vehicle (See GEN-
ERAL SPECIFICATIONS on page 161. Place the shifter
in the P (park) position and remove the key from the vehi-
cle. Secure the vehicle to the trailer using ratchet tie
downs.
PROLONGED STORAGE
Battery
During periods of storage, the battery must be maintained
to prevent discharge. If a battery is left in a discharged
state, sulfating will cause permanent damage to the bat-
tery. In order to prevent damage, the battery should be
recharged.
Engine
To reduce the possibility of severe
injury or death resulting from a pos-
sible explosion:
Do not handle fuel in an area that is not adequately
ventilated. Do not smoke near the fuel tank or refuel
near open flame or electrical items which could pro-
duce a spark.
Store the vehicle in a clean, dry area. Do not store in
the same area as a stove, furnace, water heater, or
other appliance that uses a a pilot light or has a
device that can create a spark.
When refueling, inspect the fuel cap for leaks or
breaks that could result in fuel spillage.
Always wear safety glasses while refueling to pre-
vent possible eye injury from gasoline or gasoline
vapor.
Keep hands, clothing and jewelry away from moving
parts. Use care not to contact hot objects. Raise the
vehicle and support on jack stands before attempt-
ing to run the engine.
Preparing the engine for a prolonged storage period of 30
days or longer requires some simple steps to prevent var-
nish, gum and corrosion in the throttle body and in the
engine.
1.
Perform all periodic routine maintenance per the
periodic service schedule.
2. Place the shifter in the P (park) position.
3. Add a commercially available fuel stabilizer to the
fuel tank. Follow the manufacturer’s mixing instruc-
tions.
4. Start the engine and let it run for several minutes in a
well ventilated area to allow the fuel stabilizer to be
mixed through the fuel system.
5. Allow the engine to run until the system is depleted
of fuel.
6. Turn the key switch to the OFF position and remove
the key.
7. Remove both ignition coils from the plugs.
8. Remove both spark plugs.
9. Add a conventional cylinder fogging oil or one ounce
of 30 weight oil to each spark plug hole.
10. Inspect the spark plugs prior to installation. Replace
if needed.
11. Rotate the engine several times with the starter. This
will allow the fogging oil to coat the cylinders.
12. Install the ignition coils onto the spark plugs.