Textron Stampede 900 2017, Руководство по ремонту и обслуживанию

Страница: 134 / 237

122
B
Repair and Service Manual
ENGINE AIR INTAKE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
668061
ENGINE AIR INTAKE
NOTICE: Hardware that is removed must always be
installed in its original position unless otherwise
specified. If torque values are not specified, refer to
the Torque Specifications Table. See TORQUE
SPECIFICATIONS on page ix.
Air Filter Maintenance
The air filter must be serviced for optimum engine life and
performance. See SCHEDULED MAINTENANCE
CHART on page 166.
Fig. 2 Air Filter
NOTICE: Do not use petroleum solvents, pressur-
ized water, or compressed air to clean the air filter
cartridge. Doing so will damage the cartridge and
will damage the engine.
NOTICE: The paper air filter cartridge is a dry unit.
Do not use oil on the cartridge.
1. Remove the seat bottom to access the air filter hous-
ing that is located below the driver seat.
2. Unlatch the cover to access the air filter cartridge
(Ref. Fig. 3).
3. Remove the filter from the housing (Ref. Fig. 2).
4. Inspect the filter. Replace if dirty or at the first sign of
filter paper deterioration. Light dust or debris may be
removed by lightly tapping out the dust. Do not use
compressed air on the filter.
5. If necessary, vacuum or wipe out any loose dirt or
debris from the air cleaner housing and cover.
6. Check for loose, clogged or damaged air intake
hoses.
7. Reinstall or replace the filter. Make sure it is fully
seated in the housing.
8. Replace the housing and secure with latches.
9. Replace the seat bottom.
Fig. 3 Air Filter Housing
Fig. 4 Air Intake Hoses
Air Filter Housing Removal
Tool List Qty.
Screwdriver, Flat Tip ....................................................1
Ratchet.........................................................................1
Socket, 10mm ..............................................................1
Wrench, 10mm.............................................................1
To remove the air filter housing:
1.
Remove the seat bottom.
2. Loosen the air hose clamps and slide the hoses off
of the housing (Ref. Fig. 1)(Ref. Fig. 4).
3. Remove the two bolts that secure the housing to the
vehicle.
4. Remove the housing.
5. Installation is the reverse of removal.
Air Filter
Cartridge
Air Filter
Housing
Latch
Cover
Air Filter
Housing
Air Intake
Hoses