Textron Stampede 900 2017, Руководство по ремонту и обслуживанию

Страница: 82 / 237

B
70
Repair and Service Manual
FRONT CV SHAFT, SUSPENSION AND STEERING
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
668061
Fig. 7 Ball Joint Separation
Fig. 8 Tap Spindle with Hammer
Remove the cotter pin (31) and castle nut (30) that secure
the spindle to the upper control arm (Ref. Fig. 9). Tap the
spindle assembly downward with a hammer to separate it
from the ball joint (Ref. Fig. 8).
Fig. 9 Spindle Nut and Cotter Pin
Fig. 10 Remove Spindle Hardware
6. Remove the cotter pin (31) and castle nut (30) that
secure the spindle to the lower control arm (Ref. Fig.
10). Tap the spindle assembly downward with a
hammer to separate it from the ball joint.
7. Slide the spindle assembly off of the CV axle splines.
8. The installation of the spindle assembly is the
reverse of disassembly.
9. Tighten the hardware to the torque values specified
below:
Item Torque Specification
2 17 - 20 ft. lbs. (23 - 27 Nm)
30 18 - 22 ft. lbs. (24 - 30 Nm)
31
30