Terex Genie S-80 SC, Руководство оператора

Страница: 32 / 78

Operator's Manual Second Edition • Second Printing
Controls
30 S
®
-80 XC
™
• S
®
-85 XC
™
Part No. 1311085GT
19 Drive enable switch
To drive when the drive enable light is
flashing, hold the drive enable switch to either
side and slowly move the drive control handle
off center. Be aware that the machine may
move in the opposite direction that the drive
and steer controls are moved.
20 Drive speed select switch
Machine on incline symbol: Low range
operation for inclines.
Machine on level surface symbol: High range
operation for maximum drive speed.
21 Steer mode select switch (if equipped)
Move the steer mode select switch to the left
to select square-end steer. Move the steer
mode select switch to the right to select
coordinated steer.
22 Auxiliary power switch
Use auxiliary power if the primary power
source fails.
Simultaneously hold the auxiliary power switch
up or down and activate the desired function.
23 Engine RPM select switch
Move the engine RPM select switch to the
turtle position to activate low idle. Move the
engine RPM speed select switch to the rabbit
position to activate high idle.
24 Engine start switch
Move the engine start switch to either side to
start the engine.
25 Not used
26 Thumb rocker switch for boom extend/retract
function
Push the top of the rocker
switch and boom will retract.
Push the bottom of the rocker
switch and the boom will
extend.
27 Dual axis proportional control handle for boom
up/down and turntable rotate left/right
functions
Move the control handle up and
the boom will raise. Move the
control handle down and the
boom will lower.
Move the control handle to the
right and the turntable will rotate
to the right. Move the control
handle to the left and the
turntable will rotate to the left.