Tennant T600e, Руководство по эксплуатации

Страница: 169 / 231

169 T600/T600e 9016605 (04-2018)
SERVICE
14. Remove the skirt cover from the idler plate.
15. Adjust the brush taper. Turn the idler plug clockwise
to increase the taper at that end of the brush and
counterclockwise to decrease the taper at that end
of the brush.
16. Reinstall the skirt cover onto the idler plate and
reinstall the idler plate assembly onto the scrub
head.
17. If necessary, repeat Step 13 through Step 16 to
adjust the taper for the other brush (idler plate is
located on the other side of the scrub head).
18. Reapply chalk and repeat Step 5 through Step 16
as necessary.
19. If the brushes are not the same width front-to-rear,
proceed to the following steps.
20. Loosen the hex screw securing the leveler screw
into place on the scrub head pivot.
21. Adjust the leveler screw up to decrease the rear
brush width and down to increase the rear brush
width.
22. Tighten the previously loosened hex screw.
23. Recheck the brush width. Repeat Step 19 through
Step 22 as necessary.